how do I display the error codes on a 2003 Dodge Intrepid?

Question

There is some combination of things to do that will display the engine error codes on the digital odometer. I do not have the manual in my possession (it's at home, I'm at work) and the check engine light came on as I was on the way to work. I have done this in the past, just can't recall how to do it. I've been searching the web, but all of the results have been about "I have error code x, what do I do?" and all I want is to find out how to get those error codes.

Thanks!

Answer 1

you,ll get a more accurate description of whats going on with it if you use a scanner to do it with ,the above answer is right ,but all it will give you is a code,the scanner will also list a cause for the the code,good luck.

Answer 2

Dodge Error Codes

Answer 3

•Codes are displayed on digital odometers on newer models.

•On many 2001 and newer models, holding in the trip odometer reset button while turning the key to RUN will start a self test, with a readout on the odometer. It will also activate all instrument panels, one at a time. We do not know if this will show computer codes, or whether it only tests the instrument panels. At the end, it may show a few odd codes that are firmware versions and not error codes.

•On most cars, the codes will read out if the engine light is on - all you have to do is put the key into the RUN position.

•Normally, to get codes, you put the key on OFF and then rapidly do OFF-ON-OFF-ON-OFF-ON (on some cars you have to do four or five, not three, OFF-ON cycles). On our test 2002 car, the key did not go back to unlock, so it was ACC-ON-ACC-ON-ACC-ON.

Answer 4

only with an obd2 tester most shops will pull codes for free just dont tell them u are gonna fix it your self